Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Standard cylinder bore diameter:
10.285 to 10.306 mm (0.4049 to 0.4057 in.)
Select a new guide bush (STD or O/S 0.05).
Standard bush bore diameter:
Bush Size
Specified Condition
Use STD
10.335 to 10.356 mm (0.4069 to 0.4077 in.)
Use O/S 0.05
10.285 to 10.306 mm (0.4049 to 0.4057 in.)
HINT:
If the bush bore diameter of the cylinder head is greater than 10.344 mm (0.4072 in.), machine the bush bore diameter to between 10.383 and 10.394 mm (0.4088 and 0.4092 in.).
If the bush bore diameter of the cylinder head is greater than 10.344 mm (0.4072 in.), replace the cylinder head.
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Standard cylinder bore diameter:
10.285 to 10.306 mm (0.4049 to 0.4057 in.)
Select a new guide bush (STD or O/S 0.05).
Standard bush bore diameter:
Bush Size
Specified Condition
Use STD
10.335 to 10.356 mm (0.4069 to 0.4077 in.)
Use O/S 0.05
10.285 to 10.306 mm (0.4049 to 0.4057 in.)
HINT:
If the bush bore diameter of the cylinder head is greater than 10.344 mm (0.4072 in.), machine the bush bore diameter to between 10.383 and 10.394 mm (0.4088 and 0.4092 in.).
If the bush bore diameter of the cylinder head is greater than 10.344 mm (0.4072 in.), replace the cylinder head.
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.