REPAIR
Removal / installation · Vehicles built from Aug 2007
| 1.
REPAIR INTAKE VALVE SEAT |
 |
- NOTICE:
- Keep the lip free from foreign matter.
- If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
- If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.
Hand-lap the valve and valve seat with an abrasive compound.
Check the valve seating position.
| 2.
REPAIR EXHAUST VALVE SEAT |
 |
- NOTICE:
- Keep the lip free from foreign matter.
- If the seating is too high on the valve face, use 30° and 45° cutters to correct the seat.
- If the seating is too low on the valve face, use 45° and 75° cutters to correct the seat.
Hand-lap the valve and valve seat with an abrasive compound.
Check the valve seating position.