2005-2008 RAV4 · Service Manual STEERING

FREEZE FRAME DATA

Troubleshooting · Vehicles built from Nov 2005


FREEZE FRAME DATA

NOTICE:
  1. It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.
  2. Turn the ignition switch on (IG) and park the vehicle on level ground. Check the freeze frame data by using intelligent tester.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and check the freeze frame data by following the prompts on the intelligent tester display.

    Power steering ECU:  
    Item
    Item Description: Range (Display)
    Inspection Condition
    Reference Value
    Battery Voltage
    Battery voltage:
    Min.: 0 V
    Max.: 25.5 V
    -
    10 to 14 V
    Meter Vehicle Velocity
    Vehicle speed from meter:
    Min.: 0 km/h (0 mph)
    Max.: 300 km/h (187.5 mph)
    Vehicle stopped
    0 km/h (0 mph)
    Vehicle driven at constant speed
    No significant fluctuation
    Engine Revolution
    Show the engine revolution:
    Min.: 0 rpm
    Max.: 12800 rpm
    Engine is running at a constant speed
    No significant fluctuation
    Motor Actual Current
    Amount of current to motor:
    Min.: -327.68 A
    Max.: 327.67 A
    Power steering is in operation
    Value changes in proportion to steering effort
    Command Value Current
    Demanded amount of current to motor:
    Min.: -327.68 A
    Max.: 327.68 A
    Power steering is in operation
    Value changes in proportion to steering effort
    Steering Angle Velocity
    Steering angle speed:
    Min.: -32768°/sec.
    Max.: 32767°/sec.
    Steering wheel is turned
    Value changes in proportion to steering effort
    Steering Wheel Torque
    Steering wheel torque:
    Min.: -7 Nm
    Max.: 7 Nm
    -
    -
    Thermistor Temperature
    ECU substrate temperature:
    Min.: -40°C
    Max.: 150°C
    Ignition switch on (IG)
    -
    PIG Power Supply
    Power source voltage to activate motor:
    Min.: 0 V
    Max.: 20.1531 V
    Power steering in operation
    10 to 14 V
    IG Power Supply
    ECU power source voltage:
    Min.: 0 V
    Max.: 20.1531 V
    Ignition switch on (IG)
    10 to 14 V
    Motor Rotation Angle
    Motor rotation angle:
    Min.: 0°
    Max.: 360°
    Power steering in operation
    During steering operation, motor rotation angle value changes from 0 to 360°
    Motor Voltage
    Motor power supply voltage:
    Min.: 0 V
    Max.: 45.955 V
    Power steering in operation
    -
    Motor Terminal Volt (U)
    Motor terminal voltage (U phase):
    Min.: 0 V
    Max.: 46.667 V
    Engine running and steering wheel turned
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    Motor Terminal Volt (V)
    Motor terminal voltage (V phase):
    Min.: 0 V
    Max.: 46.667 V
    Engine running and steering wheel turned
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    Motor Terminal Volt (W)
    Motor Terminal voltage (W phase):
    Min.: 0 V
    Max.: 46.667 V
    Engine running and steering wheel turned
    When the steering wheel is turned, a voltage between 1 V and approximately 1 V less than the battery voltage is displayed.
    PS Assist Signal
    Power steering assist signal:
    ON or OFF
    -
    -

← DTC CHECK / CLEAR (from Aug 2008)FAIL-SAFE CHART (Nov 2005 – Jul 2008) →