2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. D003654E01
    Using SST, install a new oil seal to the pump.
    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with petroleum jelly.


2. INSTALL FRONT OIL PUMP BODY O-RING

  1. C055817E03
    Coat a new O-ring with ATF, and install it to the oil pump body.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. D009206E08
    Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the maked side facing up.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D009206E09
    Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the maked side facing up.


5. INSTALL STATOR SHAFT ASSEMBLY

  1. D003651E02
    Set stator shaft by aligning each bolt hole.

  1. Using a T30 ''torx'' socket, install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }


6. INSTALL CLUTCH DRUM OIL SEAL RING

D003655E01

NOTICE:
Do not expand the ring ends excessively.

  1. Install the 2 clutch drum oil seal rings.


7. INSPECT OIL PUMP ASSEMBLY

  1. D009205E01
    Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →