INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
Install the direct clutch and needle roller bearing on the transaxle rear cover.

Using a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
- Standard pack clearance:
- 0.605 to 0.825 mm (0.0238 to 0.0325 in.)
| INSPECT DIRECT MULTIPLE DISC CLUTCH DISC |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.

If necessary, replace them.- HINT:
- If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
| INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
Using a vernier caliper, measure the free length of the spring together with the spring seat.

- Standard free length:
- 22.58 mm (0.8890 in.)
