2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSPECT UNDERDRIVE PLANETARY GEAR PRELOAD

  1. D025594E02
    Using SST a torque wrench, measure the turning torque of the underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.
    SST
    09387-00050  
    09564-16020  

    Torque:
    Standard turning torque at 60 rpm:
    0.23 to 5.01 N*m{ 2 to 51 kgf*cm , 2.0 to 44.3 in.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 160 mm (6.3 in.).


2. REMOVE CYLINDRICAL ROLLER BEARING RACE INNER

  1. D003686E01
    Using SST, loosen the staked part of the nut.
    SST
    09930-00010   (09931-00010, 09931-00020)
    09387-00050  

  1. D003687E03
    Clamp the underdrive planetary gear in soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. D025609E04
    Using SST, remove the lock nut.
    SST
    09564-16020  

  1. D003689E03
    Using SST, remove the cylindrical roller bearing inner race.
    SST
    09950-00020  
    09950-00030  
    09950-60010   (09951-00340)


3. REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY

  1. D003690E01
    Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear and front tapered roller bearing.
    SST
    09387-00050  

  1. D003691E03
    Clamp the underdrive planetary gear in soft jaw vise.

  1. Using SST, remove rear tapered roller bearing from the underdrive planetary gear.

    SST
    09950-00020  
    09950-00030  
    09950-60010   (09951-00320)


4. REMOVE UNDERDRIVE PLANETARY RING GEAR

  1. D003826E03
    Using snap ring pliers, remove the snap ring.

  1. D003827E04
    Remove the underdrive planetary ring gear from the counter driven gear.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →