2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL UNDERDRIVE PLANETARY RING GEAR

  1. D008112E02
    Install a new snap ring to the outer race of the tapered roller bearing.

  1. D008113E01
    Using a piston ring compressor, squeeze the snap ring.

  1. D008114E01
    Using SST a press, press in the outer race of the tapered roller bearing.
    SST
    09950-60020   (09951-00890)
    09950-70010   (09951-07100)

  1. D003827E04
    Install the underdrive planetary ring gear to the counter driven gear.

  1. D003826E03
    Using snap ring pliers, install the snap ring.


2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY

  1. D003692E01
    Using a press, install the tapered roller bearing.

  1. D008117E01
    Install the counter driven gear with planetary ring gear to the underdrive planetary gear.

  1. D008118E01
    Using SST and a press, press in the tapered roller bearing.
    SST
    09316-60011   (09316-00011)

    NOTICE:
    Press in the counter driven gear while rotating it.

  1. D003694E02
    Using a press, press in the parking lock gear.

    NOTICE:
    Press in the counter driven gear while rotating it.

  1. D008120E02
    Using SST and a press, press in the differential drive pinion.

    NOTICE:
    Press in the counter driven gear while rotating it.

    SST
    09506-35010  
    09950-60010   (09951-00250)

  1. D008121E02
    Using SST and a press, press in the cylindrical roller bearing inner race.

    NOTICE:
    Press in the counter driven gear while rotating it.

    SST
    09506-35010  
    09950-60010   (09951-00250)

  1. D025609E05
    Clamp the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. Using SST, install a new lock nut.

    Torque:
    280 N*m{ 2,855 kgf*cm , 207 in.*lbf }

    SST
    09564-16020  

    HINT:
    Use a torque wrench with a fulcrum length of 750 mm (29.53 in.)

  1. D025594E02
    Using SST and a torque wrench, measure the turning torque of underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.
    SST
    09564-16020  
    09387-00050  

    Torque:
    Standard turning torque at 60 rpm:
    0.23 to5.01 N*m{ 2 to 51 kgf*cm , 2.0 to 44.3 in.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 160 mm (6.30 in.).

  1. D003852E01
    Using a pin punch and hammer, stake the lock nut.

    NOTICE:
    Make sure that there are no cracks on the nut.

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →