DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. REMOVE FRONT DIFFERENTIAL RING GEAR |
Place the matchmarks on the ring gear and differential case.

Remove the 10 bolts.

Using a plastic-faced hammer, tap on the ring gear to remove it from the case.

| 2. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
Using SST, remove the front differential case tapered roller bearing front inner race from the differential case.

- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
09950-60010 (09951-00340)
Using SST, remove the front differential case tapered roller bearing front outer race and differential case washer.

- SST
- 09387-00041
(09387-01030, 09387-01040, 09387-02010, 09387-02020)
| 3. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
Using SST, remove the front differential case tapered roller bearing rear inner race from the differential case.

- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)
09950-60010 (09951-00340)
Using SST, remove the front differential case tapered roller bearing rear outer race from the differential case washer.

- SST
- 09387-00041
(09387-01030, 09387-01040, 09387-02010, 09387-02020)
| 4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
Using a punch and hammer, loosen the staked part of the differential case.

Using a pin punch (5 mm), tap out the pin from the ring gear side.

| 5. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT |
Remove the front differential pinion shaft from the differential case.

| 6. REMOVE FRONT DIFFERENTIAL SIDE GEAR |
Remove the 2 front differential pinions, 2 pinion thrust washers, 2 front differential side gears and 2 side gear thrust washers from the differential case.

| 7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL |
Place the transaxle case in a vise.

Using SST, remove the oil seal.
- SST
- 09308-00010
| 8. REMOVE TRANSAXLE HOUSING OIL SEAL |
Place the transaxle housing in a vise.

Using SST, remove the oil seal.
- SST
- 09308-00010
