REMOVAL
Removal / installation · Vehicles built Aug 2007 – Jul 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
| 1.
REMOVE FUEL TANK ASSEMBLY |
 |
Remove the fuel tank (Click here).
| 2.
DISCONNECT FUEL EMISSION HOSE
|
 |
- Remove the purge line hose, air inlet line hose and EVAP line tube from the fuel pump.
| 3.
DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
|
 |
- Remove the joint clip and fuel tank main tube.
- CAUTION:
- Before removing the tube joint clip, Check for foreign matter around the clip. Clean if necessary.
- Keep the O-ring free of foreign matter, as it becomes contaminated easily.
- Do not use any tools in this procedure.
- Do not forcefully bend or twist the tube.
- Put the tube in a plastic bag to prevent damage and contamination.
- If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
- Be careful not to damage the clip. If the clip is damaged, replace it.
| 4.
REMOVE FUEL TANK VENT TUBE SET PLATE
|
 |
- Remove the 8 bolts and set plate.
| 5.
REMOVE FUEL SUCTION WITH PUMP ASSEMBLY
|
 |
- Disconnect the fuel hose and remove the fuel pump from the fuel tank.
- NOTICE:
- Do not damage the fuel pump.
- Remove the gasket from the fuel pump.
| 6.
REMOVE FUEL SUB-TANK ASSEMBLY |
 |
- Disconnect the wire harness.
- Using needle nose pliers, remove the E-ring.
- HINT:
- Slightly lower the sub-tank to remove the E-ring.
- Remove the 2 springs from the 2 shafts.
- Detach the 2 claws and remove the sub-tank.
| 7.
REMOVE BRACKET |
 |
- Using a screwdriver, detach the 2 claws and remove the bracket.
- HINT:
- Tape the screwdriver tip before use.
| 8.
REMOVE FUEL PUMP ASSEMBLY |
 |
- Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.
- HINT:
- When detaching the claw, do not disconnect the fuel main tube.
- Disconnect the fuel pump connector.
- Remove the O-ring from the fuel filter.
| 9.
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
 |
- Remove the pressure regulator from the fuel filter.
Remove the 2 O-rings.