2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Nov 2005 – Jul 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE RADIATOR SUPPORT OPENING COVER

3. REMOVE BATTERY CLAMP
  1. Remove the bolt, nut and clamp.


4. REMOVE BATTERY

5. REMOVE NO. 1 ENGINE UNDER COVER

6. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the cylinder block drain cock plug.

    A112179E01


7. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  1. B135282
    Remove the 4 bolts and 4 nuts.

  1. B136794
    Detach the 6 claws and remove the radiator grille.


8. DISCONNECT HOOD LOCK SWITCH CONNECTOR

A112308

9. DISCONNECT NO. 1 WATER BY-PASS HOSE
  1. Disconnect the hose from the radiator reservoir.


10. DISCONNECT NO. 5 WATER BY-PASS HOSE
  1. Disconnect the hose from the radiator.


11. REMOVE NO. 1 WATER BY-PASS PIPE
  1. Disconnect the pipe from the No. 1 radiator hose.

  1. Remove the 2 bolts and the pipe.

    A112333E01


12. DISCONNECT COOLING FAN MOTOR HARNESS
  1. Disconnect the 2 fan motor connectors from the 2 fan motors.

  1. Detach the 5 harness clamps from the fan shroud and upper radiator support.

    A114326


13. DISCONNECT HORN CONNECTOR
  1. Disconnect the 2 horn connectors.


14. REMOVE UPPER RADIATOR SUPPORT BRACKET

  1. A112185
    Remove the 2 bolts and the 2 upper radiator support brackets.


15. REMOVE NO. 2 FAN SHROUD

  1. A112186
    Remove the 2 bolts.

  1. Detach the 2 claws and No. 2 shroud.


16. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

  1. A112338
    Remove the 4 bolts and upper radiator support with hood lock.


17. DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE (for Automatic Transaxle)
  1. Disconnect the oil cooler hose for U241E (2WD) (Click here).

  1. Disconnect the oil cooler hose for U140F (4WD) (Click here).


18. DISCONNECT NO. 2 TRANSMISSION OIL COOLER HOSE (for Automatic Transaxle)
  1. Disconnect the oil cooler hose for U241E (2WD) (Click here).

  1. Disconnect the oil cooler hose for U140F (4WD) (Click here).


19. DISCONNECT NO. 1 RADIATOR HOSE

20. DISCONNECT NO. 2 RADIATOR HOSE

21. DISCONNECT NO. 2 WATER BY-PASS HOSE

Disconnect the by-pass hose from the radiator reservoir and radiator.

A112334E01

22. REMOVE RADIATOR ASSEMBLY
  1. Separate the cooler condenser from the radiator.

    HINT:
    After detaching the condenser, make sure that all 4 fan shroud cushions are present.

  1. A114339
    Remove the radiator with the 2 radiator support lowers.

    HINT:
    After detaching the radiator, make sure that both radiator support lowers are present.


23. REMOVE FAN SHROUD WITH COOLING FAN

  1. A114328
    Remove the 2 bolts and fan shroud with cooling fan from the radiator.

← ON-VEHICLE CLEANING (from Nov 2005)REMOVAL (from Aug 2007) →