Removal / installation · Vehicles built Nov 2005 – Jul 2007
Versions by build date: Nov 2005 – Jul 2007from Aug 2007
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE RADIATOR SUPPORT OPENING COVER
3.
REMOVE BATTERY CLAMP SUB-ASSEMBLY
4.
REMOVE BATTERY
5.
REMOVE NO. 1 ENGINE UNDER COVER
6.
DRAIN ENGINE COOLANT
Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the cylinder block drain cock plug.
7.
REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Remove the 4 bolts and 4 nuts.
Detach the 6 claws and remove the radiator grille.
8.
DISCONNECT HOOD LOCK SWITCH CONNECTOR
9.
DISCONNECT NO. 1 WATER BY-PASS HOSE
Disconnect the hose from the radiator reservoir.
10.
DISCONNECT NO. 5 WATER BY-PASS HOSE
Disconnect the hose from the radiator.
11.
REMOVE NO. 1 WATER BY-PASS PIPE
Disconnect the pipe from the No. 1 radiator hose.
Remove the 2 bolts and the pipe.
12.
DISCONNECT COOLING FAN MOTOR HARNESS
Disconnect the 2 fan motor connectors from the 2 fan motors.
Detach the 5 harness clamps from the fan shroud and upper radiator support.
13.
DISCONNECT HORN CONNECTOR
Disconnect the 2 horn connectors.
14.
REMOVE UPPER RADIATOR SUPPORT BRACKET
Remove the 2 bolts and the 2 upper radiator support brackets.
15.
REMOVE NO. 2 FAN SHROUD
Remove the 2 bolts.
Detach the 2 claws and remove the No. 2 shroud.
16.
REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
Remove the 4 bolts and upper radiator support with hood lock.