INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Using a vernier caliper, measure the free length of the compression spring.

- Minimum length:
- 41.5 mm (1.634 in.)
Install a new gasket by hand so that its surface is flush with the exhaust manifold.

- NOTICE:
- Make sure the gasket is facing the correct direction.
- Do not reuse the removed gasket.
- Do not push in the gasket while installing the front exhaust pipe.
- Make sure the gasket is facing the correct direction.
Install the front exhaust pipe with the 2 compression springs and 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }


| 2. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Install a new gasket onto the front exhaust pipe.

Connect the 3 exhaust pipe supports, and install the center exhaust pipe.
Install the 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }


| 3. INSTALL TAILPIPE ASSEMBLY |
Using a vernier caliper, measure the free length of the compression spring.

- Minimum length:
- 38.5 mm (1.516 in.)
Install a new gasket by hand so that its surface is flush with the center exhaust pipe.

- NOTICE:
- Make sure the gasket is facing the correct direction.
- Do not reuse the removed gasket.
- Do not push in the gasket while installing the tailpipe.
- Make sure the gasket is facing the correct direction.
Connect the 2 exhaust pipe supports, and install the tailpipe.
Install the 2 compression springs and 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }


| 4. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() ![]() |
Using SST, install the sensor to the front exhaust pipe.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure SST and wrench are connected in a straight line.
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. CHECK FOR EXHAUST GAS LEAKS |

