2005-2008 RAV4 · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL BRAKE ACTUATOR BOLT CUSHION
  1. Install the 3 cushions to the actuator.


2. INSTALL BRAKE ACTUATOR BOLT HOLDER
  1. Install the 2 bolt holders to the actuator.


3. INSTALL BRAKE ACTUATOR ASSEMBLY

NOTICE:
Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.

  1. Set the actuator on the bracket.

    NOTICE:

    1. C127956E01
      Insert the cushion to the pin of the bracket securely.

    2. C127957E01
      The clearance between the cushion bolt and bracket is less than 1.0 mm (0.039 in.).
    3. The projection should be set as shown in the illustration.

  1. C129071
    Install the 2 nuts to assemble the actuator and bracket.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← DISASSEMBLY (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →