REMOVAL
Removal / installation · Vehicles built Nov 2005 – Jul 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 3.
REMOVE FRONT FENDER LINER LH |
|
| 4.
REMOVE FRONT SPEED SENSOR LH |
 |
- Disconnect the sensor connector.
- Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


- Remove the bolt and sensor body from the knuckle.
- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.