2005-2008 RAV4 · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL STEERING ANGLE SENSOR

  1. C128529
    Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.


2. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for LHD)
  1. Install the spiral cable onto the turn signal switch.

  1. C128493E03
    Connect all the connectors to the turn signal switch with spiral cable.


3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for RHD)
  1. Install the spiral cable onto the turn signal switch.

  1. C127466E01
    Connect all the connectors to the turn signal switch with spiral cable.


4. INSTALL STEERING COLUMN COVER (for LHD)

  1. C128492
    Attach the claw to install the upper steering column cover.

  1. C128491
    Attach the 4 claws to install the lower steering column cover.


5. INSTALL STEERING COLUMN COVER (for RHD)

  1. C127465
    Attach the claw to install the steering column cover upper.

  1. C127464
    Attach the 4 claws to install the steering column cover lower.


6. INSTALL STEERING WHEEL ASSEMBLY (for LHD)

  1. C132123E02
    Align the matchmarks and install the steering wheel onto the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.


7. REMOVE STEERING WHEEL ASSEMBLY (for RHD)

  1. C132125E02
    Align the matchmarks and install the steering wheel onto the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.


8. INSTALL STEERING PAD ASSEMBLY

B127893E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. B130245E02
    Using a T30 "torx" driver, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


9. INSPECT STEERING WHEEL CENTER POINT

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.


12. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← INSTALLATION (Nov 2005 – Dec 2006)INSTALLATION (from Aug 2007) →