2005-2008 RAV4 · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
  1. Use the procedures below to troubleshoot the power door lock control system.
  2. *: Use the Intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTCs.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      ResultĀ 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      ResultĀ 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed on problem symptoms table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here ).

    2. Terminal of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2005)OPERATION CHECK (from Nov 2005) →