2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built Nov 2005 – Jul 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007


INSPECT TIRE
  1. Measure the tires for wear and proper inflation pressure.

    Standard cold tire inflation pressure:
    220 kPa (2.2 kgf/cm2, 32 psi)

  1. R003031
    Using a dial indicator, check the runout of the tires.

    Standard tire runout:
    1.0 mm (0.039 in.) or less


ROTATE TIRE

C134965E02

HINT:
  1. Rotate the tires as shown in (A) in the illustration if the spare tire and its wheel are the same as the vehicle's other tires.
  2. Rotate the tires as shown in (B) in the illustration if the spare tire or its wheel is different from the vehicle's other tires, or if the vehicle is not equipped with a spare tire.


INSPECT WHEEL BALANCE
  1. Check and adjust the off-the car balance.

    Standard imbalance after adjustment:
    8.0 g (0.018 lb) or less


CHECK FRONT AXLE HUB BEARING

C127532E01
  1. Remove the front wheel.

  1. Disconnect the front disc brake cylinder (Click here).

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, measure the backlash near the center of the axle hub.

      Maximum backlash:
      0.05 mm (0.0020 in.)

      1. If the backlash is greater than the maximum, replace the bearing.

  1. Inspect the axle hub deviation.

    1. Using a dial indicator, measure the deviation on the surface of the axle hub.

      Maximum deviation:
      0.05 mm (0.0020 in.)

      1. If the deviation is greater than the maximum, replace the bearing.


CHECK BEARING BACKLASH AND AXLE HUB DEVIATION

  1. C127564E01
    Using a dial indicator, measure the backlash near the center of the axle hub.

    Maximum backlash:
    0.05 mm (0.0020 in.)

    If the backlash is greater than the maximum, replace the axle hub.

  1. Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.

    Maximum deviation:
    0.08 mm (0.0031 in.) for 2WD
    0.06 mm (0.0024 in.) for 4WD

    If the deviation is greater than the maximum, replace the axle hub.

← PRECAUTION (from Nov 2005)INSPECTION (from Aug 2007) →