Power Source Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
This circuit provides power to the auto wiper relay.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (WIP) |
Remove the WIP fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. INSPECT IG1 RELAY |
![]() ![]() |
Remove the IG1 relay from the instrument panel junction block.
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (RELAY - BATTERY AND BODY GROUND) |
![]() ![]() |
Disconnect the E66 relay connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Switch Condition
Specified Condition
E66-12 (IG) - Body ground
Ignition switch on (IG)
10 to 14 V
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
E66-26 (E) - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||


