ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT MANUAL TRANSAXLE OIL |
Stop the vehicle in a level place.
Remove the transaxle filler plug and gasket.
Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the filler plug opening. If the result is not as specified, add transaxle oil.

- Oil grade:
- GL-4
- Viscosity:
- SAE 75W
- Standard capacity:
- 2.5 liters (2.6 US qts, 2.2 Imp. qts)
- NOTICE:
- Too much or too little oil will lead to transaxle problems.
- After adjusting the oil level, drive the vehicle and check the oil level again.
- Too much or too little oil will lead to transaxle problems.
Check for oil leakage if the oil level is low.
Install the transaxle filler plug and a new gasket.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
