PRECAUTION
Precautions · Vehicles built from Nov 2005
| 1.TROUBLESHOOTING PRECAUTION |
- NOTICE:
- Since the active torque control system (4WD control system) may be influenced by a malfunction in other systems, be sure to check for DTCs in the other systems.
- When removing and installing the 4WD control ECU and each sensor, be sure to check that the normal display is output in test mode inspection and in DTC output inspection after installing all the parts.
- If the DTC of the CAN communication line is output, repair the malfunction in the communication line and troubleshoot the 4WD control system.
- Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
- When performing inspections after replacing the 4WD control ECU with a normal one from another vehicle, be sure to perform zero point calibration of the yaw rate sensor by connecting terminals TS and CG of the DLC3 (Click here).
- Since the active torque control system (4WD control system) may be influenced by a malfunction in other systems, be sure to check for DTCs in the other systems.
- HINT:
- Calibrate the 4WD control ECU by performing calibration of the vehicle stability control system.
| 2.IGNITION SWITCH EXPRESSIONS |
- HINT:
- The type of ignition switch used on this model differs according to the vehicle. The expressions listed in the table below are used in this section.
| Expressions |
Ignition Switch (position) |
Engine Switch (condition) |
| Ignition Switch off |
LOCK |
Off |
| Ignition Switch on (IG) |
ON |
On (IG) |
| Ignition Switch on (ACC) |
ACC |
On (ACC) |
| Engine Start |
START |
Start |