2005-2008 RAV4 · Service Manual DRIVE LINE

C1296/96 ABS Malfunction

Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

If a malfunction in the speed sensor signal circuit yaw rate sensor (deceleration sensor) circuit occurs, the 4WD control ECU will output this DTC.
DTC No.
DTC Detection Condition
Trouble Area
C1296/96
When either conditions below is met:
  1. Wheel speed sensor malfunction is received from skid control ECU
  2. Deceleration sensor malfunction us received from skid control ECU
  1. CAN communication line
  1. Skid control ECU
  1. Speed sensor
  1. 4WD control ECU
  1. Yaw rate sensor (Deceleration sensor)
  1. Wire harness

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG) again and check that CAN communication system DTC(s) is not output.

  1. Drive the vehicle, accelerate to a speed of 20 km/h (12 mph) or more, and check if the speed sensor DTC (brake control system DTC) is output (Click here, and Click here).

    Result 
    Result
    Proceed to
    Neither CAN communication system DTC brake control system DTC is not output
    A
    CAN communication system DTC is output
    B
    Brake control system DTC is output
    C

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



B
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (CAN COMMUNICATION SYSTEM)

C
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (BRAKE CONTROL SYSTEM)
A


2. CHECK OPERATION OF 4WD CONTROL ECU
  1. Replace the 4WD control ECU with a normally functioning or new one.

    NOTICE:
    When performing inspections after replacing the 4WD control ECU with a normal one from another vehicle, be sure to perform zero point calibration of the yaw rate sensor by connecting terminals TS and CG of the DLC3 (Click here).

    HINT:
    Calibrate the 4WD control ECU by performing calibration of the vehicle stability control system.

  1. Reconfirm DTC.

    OK:
    DTC is not output.



OK
END (4WD CONTROL ECU FAULTY)
NG

GO TO BRAKE CONTROL SYSTEM (ANTI-LOCK BRAKE SYSTEM OR VEHICLE STABILITY CONTROL SYSTEM)


← C1296/96 ABS Malfunction (Nov 2005 – Dec 2006)C1296/96 ABS Malfunction (from Aug 2007) →