2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE REAR DOOR SCUFF PLATE RH

B132566
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.


2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

3. REMOVE REAR FLOOR NO. 1 BOARD

4. REMOVE DECK BOARD ASSEMBLY

5. REMOVE REAR FLOOR NO. 3 BOARD

6. REMOVE REAR FLOOR NO. 2 BOARD

7. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE

B129705
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


8. REMOVE REAR FLOOR FINISH PLATE

B129704
  1. Using a clip remover, detach the 6 clips.

  1. Detach the 2 claws and remove the finish plate.


9. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH

  1. B135482
    Using a screwdriver, detach the 6 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.


10. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY

B137550
  1. Remove the bolt and tether anchor bracket.


11. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

  1. B137547
    Disconnect the rear No.1 seat outer belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129707
    Remove the 2 screws and 2 bolts.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the trim board.

  1. Remove the belt hanger.


12. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

B137548
  1. Using a clip remover, detach the 7 clips and remove the garnish.


13. REMOVE DOOR CONTROL RECEIVER

B132568
  1. Disconnect the receiver connector.

  1. Remove the bolt and receiver.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →