REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER
|
 |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER
|
 |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE RADIO RECEIVER (w/ Radio Receiver)
|
 |
Remove the 4 bolts.
Detach the 4 clips, remove the radio receiver and then disconnect the connectors.
| 5.
REMOVE STEREO OPENING COVER (w/o Radio Receiver)
|
 |
Remove the 4 bolts.
Detach the 4 clips and remove the stereo opening cover.
| 6.
REMOVE HEATER CONTROL ASSEMBLY |
 |
- Remove the 2 screws.
Using a screwdriver detach the 3 clips.
- HINT:
- Tape the screwdriver tip before use.
Connect the connectors and remove the heater control assembly.
| 7.
REMOVE ENGINE SWITCH |
 |
- Disconnect the switch connector.
Detach the 2 claws and remove the switch.