REMOVAL
Removal / installation · Vehicles built from Jan 2007
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() ![]() |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() ![]() |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE RADIO RECEIVER (w/ Radio Receiver) |
![]() ![]() |
Remove the 4 bolts.
Detach the 4 clips, remove the radio receiver and then disconnect the connectors.
| 5. REMOVE STEREO OPENING COVER (w/o Radio Receiver) |
![]() ![]() |
Remove the 4 bolts.
Detach the 4 clips and remove the stereo opening cover.
| 6. REMOVE HEATER CONTROL ASSEMBLY |
Remove the 2 screws.

Using a screwdriver, detach the 3 clips.
- HINT:
- Tape the screwdriver tip before use.
Connect the connectors and remove the heater control assembly.
| 7. REMOVE ENGINE SWITCH |
Disconnect the switch connector.

Detach the 2 claws and remove the switch.




