2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE SHIFT AND SELECT LEVER BUSH

C069529E01
  1. Remove the bush from the No. 2 selecting bellcrank.


2. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER

C069530E01
  1. Remove the dust cover from the No. 2 selecting bellcrank.


3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY

C069532E01
  1. Remove the nut, wave washer and No. 2 selecting bellcrank plate washer from the No. 2 selecting bellcrank.

  1. C069799E01
    Remove the selecting bellcrank support from the No. 2 selecting bellcrank.


4. REMOVE NO. 2 SELECTING BELLCRANK DUST COVER

C069531E01
  1. Remove the dust cover from the No. 2 selecting bellcrank.


5. REMOVE NO. 2 SELECTING BELLCRANK BUSH

C069798E01
  1. Remove the bushes from the No. 2 selecting bellcrank.


6. REMOVE NO. 2 SHIFT LEVER INNER

C138351
  1. Hold the shift and select lever shaft in a vise with soft jaws.

    NOTICE:
    Do not damage the shift and select lever shaft.

  1. Using a 5 mm pin punch and hammer, tap out the slotted pin and remove the transaxle oil baffle.

  1. D033407E01
    Apply force to the No. 2 select return compression spring, then using 2 screwdrivers and a hammer, tap out the No. 2 select spring seat shaft snap ring from the shift and select lever shaft.

  1. Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner.

    NOTICE:
    Use a cloth to prevent the snap ring from flying off.

  1. C135406
    Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner from the shift and select lever shaft.


7. REMOVE NO. 1 SELECT SPRING SEAT

D033280E01
  1. Using a 5 mm pin punch and hammer, tap out the slotted pin from the shift and select lever shaft.

  1. C069538E01
    Remove the shift inter lock plate assembly, shift lever assembly, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.


8. REMOVE SHIFT INTER LOCK PLATE COVER

C091167E02
  1. Remove the shift inter lock plate cover from the shift inter lock plate.


9. REMOVE NO. 1 SHIFT LEVER INNER

C091169E02
  1. Remove the No. 1 shift lever inner from the shift inter lock plate.


10. REMOVE NO. 1 SELECT SPRING SEAT SHAFT SNAP RING

C069539E01
  1. Using 2 screwdrivers and a hammer, tap out the snap ring.


11. REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT
  1. Remove the dust boot from the control shaft cover.


12. REMOVE CONTROL SHAFT COVER OIL SEAL

  1. D032770E01
    Using a screwdriver, pry out the oil seal from the control shaft cover.

    HINT:
    Tape the screwdriver tip before use to avoid damage.

← COMPONENTS (from Nov 2005)REASSEMBLY (from Nov 2005) →