REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER
|
 |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER
|
 |
Using a screwdriver, detach the 3 clips, 3 claws and remove the cluster finish panel, then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE NAVIGATION RECEIVER ASSEMBLY |
 |
Remove the 4 screws.
Detach the 4 claws and remove the radio receiver.
Disconnect all connectors and remove the radio receiver with bracket.


- Remove the 4 screws and No. 1 radio bracket from the radio receiver.
- Remove the 4 screws and No. 2 radio bracket from the radio receiver.