2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Driver Side Door Entry Lock Function does not Operate

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

When the touch sensor built into the front door outside handle (for driver side) is turned on, a touch sensor ON signal is transmitted to the certification ECU, and a request signal is then transmitted to both the indoor electrical key oscillator and door electrical key oscillator by the certification ECU. Upon receipt of the request signal, the electrical key transmitter transmits an ID code to the certification ECU. When the certification ECU recognizes that the key is not in the cabin and is outside the vehicle, a door lock signal is transmitted to the main body ECU, causing all the doors to be locked.

WIRING DIAGRAM

B133528E01

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. By following the tester screen display, check whether any DTCs are output.

    OK:
    No DTC output.



NG
Go to DIAGNOSTIC TROUBLE CODE CHART
OK


2. CHECK MANUAL DOOR LOCK OPERATION
  1. Check that all the doors lock when the door control switch (for manual operation) is turned to LOCK.

    OK:
    All doors can be lock and unlock with door control switch.



NG
Go to POWER DOOR LOCK CONTROL SYSTEM
OK


3. CHECK WIRELESS DOOR LOCK CONTROL OPERATION
  1. Check that the wireless door lock and unlock functions operate normally (Click here).

    OK:
    Wireless door lock and unlock functions operate normally.



NG
Go to WIRELESS DOOR LOCK CONTROL SYSTEM (w/ ENTRY AND START SYSTEM)
OK


4. READ VALUE USING INTELLIGENT TESTER (LOCK SWITCH)
  1. Check the Data List for proper functioning of the door lock switch.

    Certification ECU: 
    Item
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    D-Door Trigger Switch
    Driver side outside door handle (lock switch) / ON or OFF
    ON: Lock switch is pushed
    OFF: Lock switch is not pushed
    -

    OK:
    On tester screen, item changes between ON and OFF according to above chart.



NG
Go to step 6
OK


5. CHECK ECU AGGREGATION BOX (OPERATION)
  1. Temporarily replace the ECU aggregation box (certification ECU) with a new or normally functioning one.

  1. Check that the entry lock and unlock functions operate normally (Click here).

    OK:
    Entry lock and unlock functions operate normally.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
OK

END (CERTIFICATION ECU IS DEFECTIVE)

6. INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)
B127163E02
  1. Disconnect the front door outside handle (for driver side) connector.

  1. Measure the resistance between the terminal when the trigger switch is operated.

    Standard resistance:
    Tester Condition
    Condition
    Specified Condition
    1 - 3
    Switch released
    10 kΩ or higher
    Switch pressed in
    Below 1 Ω



NG
REPLACE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR


← Front Passenger Side Door Entry Lock and Unlock Functions do not Operate (from Nov 2005)Front Passenger Side Door Entry Lock Function does not Operate (from Nov 2005) →