2005-2008 RAV4 · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

  1. Measure the resistance of the power switch.

    E124645E01

    Standard resistance:
    for Front passenger switch:
    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-15 (D)
    H2-6 (B) - H2-16 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    H2-1 (E) - H2-15 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    H2-6 (B) - H2-15 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-15 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-16 (U)
    Below 1 Ω
    H2-16 (U) - H2-15 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-16 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-15 (D)
    Below 1 Ω
    for Rear LH switch:
    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-13 (D)
    H2-6 (B) - H2-12 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    H2-1 (E) - H2-13 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    H2-6 (B) - H2-13 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-13 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-12 (U)
    Below 1 Ω
    H2-12 (U) - H2-13 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-12 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-13 (D)
    Below 1 Ω
    for Rear RH switch:
    Tester Connection
    Window Lock Switch Condition
    Power Window Switch Condition
    Specified Condition
    H2-1 (E) - H2-18 (D)
    H2-6 (B) - H2-10 (U)
    OFF
    UP
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    H2-1 (E) - H2-18 (D)
    OFF
    OFF
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    H2-6 (B) - H2-18 (D)
    OFF
    DOWN
    Below 1 Ω
    H2-1 (E) - H2-18 (D)
    ON
    UP
    10 kΩ or higher
    H2-6 (B) - H2-10 (U)
    Below 1 Ω
    H2-10 (U) - H2-18 (D)
    ON
    OFF
    Below 1 Ω
    H2-1 (E) - H2-10 (U)
    ON
    DOWN
    10 kΩ or higher
    H2-6 (B) - H2-18 (D)
    Below 1 Ω

    If the result is not as specified, replace the switch assembly.

  1. B107909E22
    Apply battery voltage to the master switch and check that the AUTO light illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (LED)
    Battery negative (-) → Terminal 1 (E)
    AUTO light illuminates

    If the result is not as specified, replace the switch assembly.

← Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) (from Nov 2005)INSPECTION (from Nov 2005) →