2005-2008 RAV4 · Service Manual BODY

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)

  1. B121542E01
    Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    1. Do not apply voltage to any terminals, except terminals 1 and 2, to avoid damaging the pulse sensor inside the motor.
    1. Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1 and 7
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1 and 7
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Passenger Side)

  1. B086400E01
    Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side)

  1. B086401E01
    Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.


INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side)

  1. B086400E01
    Apply battery voltage to connector terminals 1 and 2.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the regulator motor assembly.

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →