ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| CHECK DIFFERENTIAL OIL |
Stop the vehicle on a level surface.
Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.

Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the differential filler plug hole.

- NOTICE:
- After changing the oil seal, drive the vehicle and then check the oil level again.
- Too much or too little oil will lead to differential problems.
- After changing the oil seal, drive the vehicle and then check the oil level again.
- If there is not enough oil, inspect for oil leaks, and fill the differential carrier assembly with hypoid gear oil.
- Recommended viscosity:
- SAE 90
- Standard oil grade:
- Hypoid gear oil SX API GL-5
- Standard differential oil capacity:
- 0.45 to 0.55 liters (0.48 to 0.58 US qts., 0.40 to 0.48 Imp. qts.)
Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential filler plug.
- Torque:
- 39 N*m{ 398 kgf*cm , 29 ft.*lbf }
