2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT COIL SPRING INSULATOR LOWER LH

  1. C127549
    Install the insulator lower to the shock absorber.


2. INSTALL FRONT SPRING BUMPER LH
  1. Engage the spring bumper to the spring seat.


3. INSTALL FRONT COIL SPRING LH

  1. C127550E01
    Using SST, compress the coil spring.
    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    HINT:
    To prevent the coil spring from being damaged, wind vinyl tape around the coil spring.

    NOTICE:
    Do not use an impact wrench which will damage SST.

  1. Install the coil spring to the shock absorber.

    HINT:
    Fit the lower end of the coil spring to the gap of the lower spring seat.


4. INSTALL FRONT COIL SPRING INSULATOR UPPER LH
  1. Install the insulator upper to the shock absorber.


5. INSTALL FRONT COIL SPRING SEAT UPPER LH
  1. Install the seat upper to the shock absorber.


6. INSTALL FRONT SUSPENSION SUPPORT LH DUST SEAL
  1. Install the dust seal to the shock absorber.


7. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Install the suspension support to the shock absorber.


8. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

  1. C127544E01
    Using SST to hold the spring upper seat, install a new nut.
    SST
    09729-22031  

    Torque:
    47 N*m{ 475 kgf*cm , 34 ft.*lbf }

  1. Remove SST.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

  1. C127553E01
    Pack the suspension support with MP grease.


9. INSTALL FRONT SUSPENSION SUPPORT DUST COVER LH
  1. Install the dust cover to the shock absorber.


10. INSTALL FRONT SUSPENSION SUPPORT PLATE LH
  1. Install the support plate to the shock absorber with coil spring.

← INSPECTION (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →