2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH

  1. C127559E01
    Support the No. 2 suspension arm LH with a jack.

    NOTICE:
    Place a wooden or rubber block between the jack and arm.

  1. Remove the bolt and 2 nuts from the suspension member and axle carrier.

  1. C129929
    Remove the 2 bolts and disconnect the shock absorber with the bracket.

  1. C127561
    Remove the nut and bolt from the shock absorber upper side.

    HINT:
    While fixing the nut in place, loosen and remove the bolt.

  1. Remove the shock absorber from the vehicle.

  1. Remove the nut and bolt from the bracket.

    HINT:
    While fixing the nut in place, loosen and remove the bolt.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →