2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. REMOVE SKID CONTROL SENSOR WIRE (for 2WD)

  1. C127328
    Disconnect the skid control sensor wire connector.

  1. C127970E01
    Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.

  1. C127967E01
    Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.

  1. Remove the 2 nuts (labeled C) and sensor clamps (labeled D) from the upper arm.

  1. C127966E01
    Remove the bolt (labeled E) and sensor clamp (labeled F) from the carrier.

  1. Disconnect the skid control sensor wire connector (labeled G) from the speed sensor.


3. REMOVE REAR SPEED SENSOR LH (for 4WD)

  1. C127328
    Disconnect the speed sensor connector.

  1. C127970E01
    Disconnect the grommet of the speed sensor wire from the hole of the wheel house.

  1. C127973E01
    Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.

  1. Remove the 2 nuts (labeled C) and sensor clamps (labeled D) from the upper arm.

  1. C127972E01
    Remove the nut (labeled E) and sensor clamp (labeled F) from the trailing arm.

  1. Remove the bolt (labeled G) and sensor body (labeled H) from the carrier.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.


4. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH

  1. C127559E01
    Support the No. 2 suspension arm.

  1. C127557
    Remove the 2 bolts and 2 nuts, and disconnect the upper control arm.

    NOTICE:
    When removing the bolts, hold the nuts in place.

← COMPONENTS (from Nov 2005)REMOVAL (Jan 2007 – Jul 2007) →