2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE REAR DOOR SCUFF PLATE LH

B129703
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.


3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

4. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY

5. REMOVE TONNEAU COVER ASSEMBLY

6. REMOVE REAR FLOOR NO. 1 BOARD

7. REMOVE DECK BOARD ASSEMBLY

8. REMOVE REAR FLOOR NO. 3 BOARD

9. REMOVE REAR FLOOR NO. 2 BOARD

10. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE

B129705
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


11. REMOVE BACK DOOR WEATHERSTRIP

12. REMOVE REAR FLOOR FINISH PLATE

B129704
  1. Using a clip remover, detach the 6 clips.

  1. Detach the 2 claws and remove the finish plate.


13. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH

14. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY

15. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

  1. B137546
    Disconnect the rear No.1 seat outer belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129706
    Remove the 2 screws and 2 bolts.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.


16. REMOVE REAR POWER OUTLET SOCKET ASSEMBLY

B133576
  1. Detach the 2 claws fittings and remove the socket.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →