INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH |
![]() ![]() |
As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.
- Standard turning torque:
- 0.98 to 3.43 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf) or less
Check for any cracks and grease leaks on the ball joint dust cover.


