REMOVAL
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 2.
REMOVE FRONT SPEED SENSOR
|
 |
- Disconnect the sensor connector.
- Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


- Remove the bolt and sensor body from the knuckle.
- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.
| 3.
REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY
|
 |
Remove the 2 bolts and cylinder.
| 4.
REMOVE FRONT DISC
|
 |
- Put matchmarks on the disc and axle hub.
Remove the disc.
| 5.
REMOVE FRONT AXLE HUB NUT
|
 |
Using SST and a hammer, unstake the staked part of the nut.
- SST
- 09930-00010
- NOTICE:
- Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.
While applying the brakes, remove the lock axle hub nut.
| 6.
DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY
|
 |
Remove the 2 nuts and bolt, and disconnect the lower arm from the ball joint.
| 7.
DISCONNECT TIE ROD END SUB-ASSEMBLY
|
 |
Remove the cotter pin and castle nut.
- Using SST, disconnect the tie rod end from the steering knuckle.
- NOTICE:
- Do not damage the tie rod end dust cover.
- SST
- 09628-62011
| 8.
REMOVE STEERING KNUCKLE WITH AXLE HUB
|
 |
Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.
- HINT:
- While fixing the nuts in place, loosen and remove the bolts.
- Put matchmarks on the drive shaft and the axle hub.
Using a plastic-faced hammer, remove the steering knuckle with axle hub.
- NOTICE:
- Be careful not to damage the boot and speed sensor rotor. Do not excessively push out the drive shaft from the axle assembly.
| 9.
REMOVE FRONT LOWER BALL JOINT ASSEMBLY |
 |
Remove the clip and nut.
Using SST, remove the front lower ball joint assembly.
- SST
- 09628-62011