2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL FRONT COIL SPRING INSULATOR LOWER LH

C127549
  1. Install the insulator lower to the shock absorber.


2. INSTALL FRONT SPRING BUMPER LH
  1. Install the spring bumper to the shock absorber.


3. INSTALL FRONT COIL SPRING LH

C127550E01
  1. Using SST, compress the coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    HINT:
    To prevent the coil spring from being damaged, wind vinyl tape around the coil spring.

    NOTICE:
    Do not use an impact wrench which will damage SST.

  1. Install the coil spring to the shock absorber.

    HINT:
    Fit the lower end of the coil spring to the gap of the lower spring seat.


4. INSTALL FRONT COIL SPRING INSULATOR UPPER LH
  1. Install the insulator upper to the shock absorber.


5. INSTALL STRUT MOUNTING BEARING LH
  1. Install the mounting bearing to the insulator upper.


6. INSTALL COLLAR
  1. Install the collar to the suspension support side.


7. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Install the suspension support to the shock absorber.


8. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

C127544E01
  1. Using SST to hold the spring upper seat, install a new nut.

    SST
    09729-22031  

  1. Remove SST.

    SST
    09727-30021   (09727-00021, 09727-00031)

    NOTICE:
    When removing SST, make sure that the suspension support is not in an inclined position, as the bearing may come apart.


9. INSTALL FRONT SUSPENSION SUPPORT DUST COVER LH
  1. Install the dust cover to the shock absorber.


10. INSTALL FRONT SUSPENSION SUPPORT PLATE LH
  1. Install the support plate to the shock absorber with coil spring.

← INSPECTION (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →