INSTALLATION
Removal / installation · Vehicles built from Aug 2007
| 1.
INSTALL STARTER ASSEMBLY |
 |
- Install the starter with the 2 bolts.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
- Connect the starter connector.
Install the terminal nut and cover the nut with the cap.
-
Torque:
- 9.8 N*m{
100 kgf*cm
, 88 in.*lbf
}
| 2.
INSTALL BATTERY BRACKET REINFORCEMENT
|
 |
- Install the bracket reinforcement with the 2 bolts.
-
Torque:
- 19 N*m{
194 kgf*cm
, 14 ft.*lbf
}
| 3.
INSTALL FRONT BATTERY BRACKET
|
 |
- Install the front battery bracket with the 4 bolts.
-
Torque:
- 19 N*m{
194 kgf*cm
, 14 ft.*lbf
}
Attach the 2 wire harness clamps.
| 4.
INSTALL BATTERY
|
 |
Install the battery and battery insulator.
| 5.
INSTALL BATTERY CLAMP SUB-ASSEMBLY
|
 |
Attach the hook of the battery clamp to the front battery bracket.
Temporarily tighten the nut and install the bolt.
Adjust the battery clamp position.
- Fully tighten the nut and bolt.
-
Torque:
- Bolt:
- 17 N*m{
170 kgf*cm
, 12 ft.*lbf
}
- Nut:
- 4.9 N*m{
50 kgf*cm
, 43 in.*lbf
}
Attach the 2 wire harness clamps.
| 6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|