B1622/81 Lost Communication with Driver Side - Side Airbag Sensor Assembly
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
The driver side - side airbag sensor consists of parts including the diagnostic circuit and the lateral deceleration sensor.When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1622/81 is set when a malfunction is detected in the driver side - side airbag sensor circuit.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1622/81 |
When one of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CONNECTION OF CONNECTOR |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor, driver side rear airbag sensor and the driver side - side airbag sensor.
- OK:
- The connectors are properly connected.
|
|
||||
| OK | |
| 2. CHECK FLOOR WIRE (OPEN) |
![]() ![]() |
Disconnect the connectors from the center airbag sensor and the driver side - side airbag sensor.
for LHD:Using a service wire, connect K10-4 (BBL+) and K10-3 (BBL-) of connector C.
- NOTICE:
- Do not forcibly insert the service wire into the terminals of the connector when connecting.
for RHD:Using a service wire, connect L6-4 (BBR+) and L6-3 (BBR-) of connector C.
- NOTICE:
- Do not forcibly insert the service wire into the terminals of the connector when connecting.
Measure the resistance of the wire harness side connector.
- Standard resistance:
- for LHD:
Tester Connection
Specified Condition
K1-8 (BBD+) - K1-15 (BBD-)
Below 1 Ω
- for RHD:
Tester Connection
Specified Condition
L18-8 (BBD+) - L18-15 (BBD-)
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK FLOOR WIRE (SHORT) |
![]() ![]() |
Disconnect the service wire from connector C.
Measure the resistance of the wire harness side connector.
- Standard resistance:
- for LHD:
Tester Connection
Specified Condition
K1-8 (BBD+) - K1-15 (BBD-)
1 MΩ or higher
- for RHD:
Tester Connection
Specified Condition
L18-8 (BBD+) - L18-15 (BBD-)
1 MΩ or higher
|
|
||||
| OK | |
| 4. CHECK FLOOR WIRE (TO B+) |
![]() ![]() |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
- Standard voltage:
- for LHD:
Tester Connection
Specified Condition
K1-8 (BBD+) - Body ground
Below 1 V
K1-15 (BBD-) - Body ground
Below 1 V
- for RHD:
Tester Connection
Specified Condition
L18-8 (BBD+) - Body ground
Below 1 V
L18-15 (BBD-) - Body ground
Below 1 V
|
|
||||
| OK | |
| 5. CHECK FLOOR WIRE (TO GROUND) |
![]() ![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Measure the resistance of the wire harness side connector.
- Standard resistance:
- for LHD:
Tester Connection
Specified Condition
K1-8 (BBD+) - Body ground
1 MΩ or higher
K1-15 (BBD-) - Body ground
1 MΩ or higher
- for RHD:
Tester Connection
Specified Condition
L18-8 (BBD+) - Body ground
1 MΩ or higher
L18-15 (BBD-) - Body ground
1 MΩ or higher
|
|
||||
| OK | |
| 6. CHECK SIDE AIRBAG SENSOR |
![]() ![]() |
Connect the connectors to the center airbag sensor.
Interchange the driver side - side airbag sensor with the front passenger side - side airbag sensor and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check for DTCs (Click here).
Result Result
Proceed to
DTC B1622/81 and B1627/82 are not
A
DTC B1627/82 is output.
B
DTC B1622/81 is output.
C
- HINT:
- DTCs other than DTC B1622/81 and B1627/82 may be output at this time, but they are not related to this check.
|
|
||||
|
|
||||
| A | ||
| ||



