2005-2008 RAV4 · Service Manual SERVICE SPECIFICATIONS

SERVICE DATA

Specifications · Vehicles built from Nov 2005

Starter assembly
Standard current: 90 A or less at 11.5 V
Starter magnetic switch assembly
Standard resistance
50 - C: Below 1 Ω
50 - Body: Below 2 Ω
Starter armature assembly
Standard resistance
Segment: Below 1 Ω
Segment - Coil core: 10 kΩ or higher
Standard length: 3.1 to 3.8 mm (0.122 to 0.150 in.)
Starter commutator end frame
Standard length: 4.0 to 9.0 mm (0.158 to 0.359 in.)
Standard resistance
Positive (+) - Negative (-): 10 kΩ or higher
Snap ring
Maximum length: 5.0 mm (0.197 in.)
Starter relay
3 - 5: 10 kΩ or higher
3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2)
Starter cut relay
(w/ Entry and Start System)
3 - 5: 10 kΩ or higher
3 - 5: Below 1 Ω (when battery voltage is applied to terminals 1 and 2)
Engine switch
7 (SS1) - 5 (GND) / 2 (SS2) - 5 (GND)
Specified resistance
Not pushed: 10kΩ or higher
Pushed: 15 Ω
Measurement condition
Battery positive 11 (SWIL) - Battery negative 4 (COM) or 5 (GND)
Battery positive 12 (INDS) - Battery negative 4 (COM) or 5 (GND)
Battery positive 13 (INDW) - Battery negative 4 (COM) or 5 (GND)
Ignition switch
LOCK: Between all terminals 10 kΩ or higher
ACC: 2 (AM1) - 3 (ACC) Below 1 Ω
ON: 2 (AM1) - 3 (ACC) Below 1 Ω
ON: 2 (AM1) - 4 (IG1) Below 1 Ω
ON: 6 (IG2) - 7 (AM2) Below 1 Ω
START: 1 (ST1) - 2 (AM1) Below 1 Ω
START: 1 (ST1) - 4 (IG1) Below 1 Ω
START: 6 (IG2) - 7 (AM2) Below 1 Ω
START: 6 (IG2) - 8 (ST2) Below 1 Ω
← TORQUE SPECIFICATIONS (from Jan 2007)TORQUE SPECIFICATIONS (from Nov 2005) →