2005-2008 RAV4 · Service Manual ENGINE

B2281 "P" Signal Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

DTC B2281 is output when there is an abnormal circuit between the main body ECU and the shift lock control ECU.
DTC No.
DTC Detection Condition
Trouble Area
B2273
Communication or communication line is abnormal between main body ECU and shift lock control ECU
  1. Main body ECU
  2. Shift lock control ECU
  3. Wire harness

WIRING DIAGRAM

A122229E07

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)

  1. A134279E01
    Disconnect the E18 main body ECU connector.

  1. Disconnect the E44 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E18-15 (P) - E44-7 (P2)
    Below 1 Ω
    E18-15 (P) or E44-7 (P2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK SHIFT LOCK CONTROL ECU
  1. Temporarily replace the shift lock control ECU with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
OK

END (SHIFT LOCK CONTROL ECU IS FAULTY)


← B2278 Engine Switch Circuit Malfunction (from Nov 2005)B2282 Vehicle Speed Signal Malfunction (+ B2283) (from Nov 2005) →