2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Detach the 3 clips and remove the V-bank cover.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the 2 cylinder block drain cock plugs.

    A126964E01


4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A173728
    Disconnect the mass air flow meter connector.

  1. Disconnect the VSV (air intake control) connector.

  1. Disconnect the 2 wire harness clamps and 2 vacuum hoses.

  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Loosen the No. 1 air cleaner hose clamp.

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


5. REMOVE THROTTLE BODY

  1. A139006
    Disconnect the 2 water by-pass hoses from the throttle body.

  1. A139007
    Disconnect the control motor connector.

  1. Remove the 4 bolts, throttle body and wire harness clamp stay.

  1. Remove the gasket from the intake air surge tank.


6. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

  1. A129464
    Disconnect the 2 water by-pass hoses from the throttle body.

  1. Disconnect the vapor feed hose.

  1. Disconnect the throttle body connector and clamp.

  1. A129467
    Disconnect the connector.

  1. Disconnect the No. 1 ventilation hose and vacuum hose.

  1. Remove the 2 bolts and throttle body bracket.

  1. Remove the 2 bolts and No. 1 surge tank stay.

  1. A139209
    Using a 5 mm socket hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts and surge tank.

  1. Remove the gasket from the surge tank.


7. REMOVE IGNITION COIL ASSEMBLY

  1. A170854
    Disconnect the 3 wire harness clamps.

  1. A170855
    Remove the 2 bolts and 2 wire harness brackets.

  1. A173666
    Disconnect the 6 ignition coil connectors.

  1. A136825
    Remove the 6 bolts and 6 ignition coils.


8. REMOVE SPARK PLUG

  1. A137604
    Remove the 6 spark plugs.

← COMPONENTS (from Aug 2007)INSTALLATION (from Aug 2007) →