INSPECTION
Inspection · Vehicles built from Aug 2007
| INSPECT FUEL SENDER GAUGE ASSEMBLY |
Remove the fuel sender gauge assembly.

Check that the float moves smoothly between F and E.
Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.
- Standard resistance:
Float Level
Resistance (Ω)
F
13.5 to 16.5
Between E and F
13.5 to 414.5 (Gradually changes)
E
405.5 to 414.5
- HINT:
- If the result is not as specified, replace the fuel sender gauge assembly.
