Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Voice Recognition Difficulty

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CONDITION
  1. Check if the voice recognition level of the system is low by using only one particular voice.

    OK:
    Voice recognition level of the system is low with any voice.

    HINT:
    Voice recognition level of the system varies depending on voice and pronunciation. This is not a malfunction.



NG
END
OK


2.CHECK MAP DISC


    I100152E12
  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks in the map disc.



NG
REPLACE MAP DISC
OK


3.CHECK MAP DISC


    I100201E04
  1. Check for dirt on the map disc surface.

    OK:
    No dirt is on the map disc surface.

    HINT:
    If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

    NOTICE:
    Do not use a conventional record cleaner or antistatic preservative.



NG
CLEAN MAP DISC
OK


4.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E04
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END