Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the skid control ECU to display 2-digit DTCs by flashing the ABS warning light.

WIRING DIAGRAM


C200425E08


INSPECTION PROCEDURE

1.CHECK DLC3 (TC VOLTAGE)


    C108847E36
  1. Turn the ignition switch to ON.

  1. Measure the voltage of the DLC3.

Standard voltage:
Tester Connection
Specified Condition
E16-13 (TC) - Body ground
11 to 14 V



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.CHECK WIRE HARNESS (DLC3 - ECM AND BODY GROUND)


    C126294E21
  1. Turn the ignition switch off.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-13 (TC) - A12-26 (TC)
    Below 1 Ω
    A12-26 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (DLC3 - BODY GROUND)


    H100769E38
  1. Measure the resistance of the DLC3.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)