Home › ENGINE ยท 2AD-FHV › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > FREEZE FRAME DATA

for Preparation Click here



DESCRIPTION
  1. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the air fuel ratio was lean or rich, as well as the other data recorded at the time of a malfunction.

    HINT:
    If it is impossible to duplicate the problem even though a DTC is stored, confirm the freeze frame data.


  1. A103809E43
    The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using an intelligent tester, 5 separate sets of freeze frame data can be checked.
    1. 3 data sets before the DTC was stored.
    2. 1 data set when the DTC was stored.
    3. 1 data set after the DTC was stored.
    1. These data sets can be used to simulate the condition of the vehicle around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.

LIST OF FREEZE FRAME DATA

Tester Display
Measurement Item
Diagnostic Note
Vehicle Speed
Vehicle speed
Speed indicated on speedometer
Engine Speed
Engine speed
-
Injection Volume
Injection Volume
-
Calculate Load
Calculated load
Load calculated by ECM
MAF
Mass air flow volume
If approximately 0.0 g/sec.:
  1. Mass air flow meter power source circuit is open or shorted
  2. VG circuit is open or shorted
  3. E2G circuit is open
Atmosphere Pressure
Atmospheric pressure
-
MAP
Absolute pressure inside intake manifold
-
Coolant Temp
Engine coolant temperature
If -40°C (-40°F), sensor circuit is open
If 140°C (284°F) or more, sensor circuit is shorted
Intake Air
Intake air temperature
If -40°C (-40°F), sensor circuit is open
If 140°C (284°F) or more, sensor circuit is shorted
Intake Air Temp (Turbo)
Intake air temperature after intercooler
If -40°C (-40°F), sensor circuit is open
If 190°C (374°F) or more, sensor circuit is shorted
Engine Run Time
Accumulated engine running time
-
Initial Engine Coolant Temp
Engine coolant temperature at engine start
-
Initial Intake Air Temp
Intake air temperature at engine start
-
Battery Voltage
Battery voltage
-
Pre Glow
Pre-glow operation
-
After Glow
After-glow operation
-
Accel Position
Accelerator pedal position sensor
-
Accel Sens. No.1 Volt %
Accelerator pedal position No. 1 output voltage
-
Accel Sens. No.2 Volt %
Accelerator pedal position No. 2 output voltage
-
Target Throttle Position
Target throttle position
-
Actual Throttle Position
Actual throttle position
-
Diesel Throttle Learn Status
Diesel throttle learn status
-
Throttle Sensor Volt %
Throttle position sensor output voltage
-
Throttle Motor DUTY
Throttle actuator
-
Injection Volume
Injection volume
-
Inj. FB Vol. for Idle
Injection feedback value for idle speed control
-
Inj Vol Feedback Learning
Injection volume feedback learning value
-
Injection Feedback Val #1
Injection volume correction for cylinder 1
-
Injection Feedback Val #2
Injection volume correction for cylinder 2
-
Injection Feedback Val #3
Injection volume correction for cylinder 3
-
Injection Feedback Val #4
Injection volume correction for cylinder 4
-
Pilot 1 Injection Period
Pilot 1 injection period
-
Pilot 2 Injection Period
Pilot 2 injection period
-
Main Injection Period
Main injection period
-
After Injection Period
Post injection period
-
Pilot 1 Injection Timing
Pilot 1 injection timing
-
Pilot 2 Injection Timing
Pilot 2 injection timing
-
Main Injection Timing
Main injection timing
-
After Injection Timing
Post injection timing
-
Injector Memory Error
EEPROM malfunction for injector
-
Reju Pilot Quantity Learning
Pilot quantity learning prohibition
-
Pilot Quantity Learning
Pilot quantity learning status
-
Fuel Press
Fuel pressure
-
Fuel Temperature
Fuel temperature
-
Target Pump SCV Current
Pump current target final value
-
Pump SCV Learning Value
Pump current learning value
-
Fuel Pressure Relief Valve
Fuel pressure relief valve operation prohibition
-
AF Lambda B1S1
Lambda equivalent ratio
-
AFS Voltage B1S1
Air fuel ratio sensor output voltage
Performing control the injection volume or control the injection volume for air fuel ratio sensor function of Active Test enables technician to check output voltage of sensor
AFS Current B1S1
Air fuel ratio sensor output current
-
Target EGR Position
Target EGR valve position
-
Actual EGR Valve Pos.
Actual EGR valve position
-
EGR Close Lrn. Val.
EGR valve fully closed position learned value
-
EGR Close Lrn. Status
EGR valve fully closed position learning status
-
EGR Operation Prohibit
EGR operation prohibition
-
Target Booster Pressure
Target booster pressure
-
VN Turbo Command
VN turbo command
-
Exhaust Temperature B1S1
Exhaust temperature sensor for B1S1
If 0°C (32°F), sensor circuit is open
If 1000°C (1832°F) or more, sensor circuit is shorted
Exhaust Temperature B1S2
Exhaust temperature sensor for B1S2
If 0°C (32°F), sensor circuit is open
If 1000°C (1832°F) or more, sensor circuit is shorted
DPF Differential Pressure
DPF differential pressure
-
Catalyst Differential Press
Standardized DPF differential pressure
-
Exhaust Fuel Addition FB
Exhaust fuel addition correction value
-
DPF Thermal Deteriorate
DPF thermal deterioration
-
DPF No Activate
DPF operation
-
DPF PM Block
DPF PM block
-
Catalyst Memory Error
EEPROM malfunction for catalyst
-
Add. INJ Flow Insufficient
Insufficient flow malfunction of exhaust addition injector
-
Add. INJ Flow Excessive
Excessive flow malfunction of exhaust addition injector
-
DPF Over temperature
Over temperature malfunction
-
Rich Spike Mal
Malfunction of exhaust addition injector
-
Starter Signal
Starter signal
-
Starter Control
Starter control
-
Neutral Position SW Signal
Neutral position switch signal
-
Clutch Switch
Clutch pedal switch assembly
-
Reverse Switch
-
-
Stop Light Switch
Stop light switch
-
A/C Signal
Air conditioning signal
-
Immobiliser Communication
Immobiliser communication
-
Time after DTC Cleared
Cumulative time after DTC cleared
-
Distance from DTC Cleared
Accumulated distance after DTC cleared
-
Warmup Cycle Cleared DTC
Warm-up cycle after DTC cleared
-
TC and TE1
TC and TE1 terminals of DLC3
-
Engine Start Time
-
-
Engine Speed (Starter Off)
-
-
Starter Count
-
-
Run Dist of Previous Trip
-
-
Electric Duty Feedback Value
-
-
A/C Duty Feedback Value
-
-
PS Duty Feedback Value
-
-
Idle Injection Volume (Min)
-
-
Electric Fan Motor
Electric fan motor
-
Received MIL from ECT
MIL status from ECT
-
Shift Position Sig from ECT
Shift position from ECT
-
A/T Oil Temp from ECT
ATF temperature from ECT
-
SPD (NO)
Output shaft speed
-
ECT Lock Up
ECT lock-up status
-
Shift SW Status (P Range)
Park/neutral position switch status
-
Kick Down Switch Status
Kick down switch status
-
Pattern Switch (PWR/M)
Pattern select switch (SPORT) status
-
Shift SW Status (R Range)
Park/neutral position switch status
-
Shift SW Status (N Range)
Park/neutral position switch status
-
Sports Shift Up SW
Sports shift up switch status
-
Sports Shift Down SW
Sports shift down switch status
-
Sports Mode Selection SW
Sports mode select switch status
-
Shift SW Status (D Range)
Park/neutral position switch status
-
A/T Oil Temperature 1
ATF temperature sensor value
-