Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for HDD)

NAVIGATION SYSTEM (for HDD) > Panel Switches do not Function

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK PANEL SWITCH
  1. Check for foreign matter around the switches that might prevent operation.

    OK:
    No foreign matter is found.



NG
REMOVE ANY FOREIGN MATTER FOUND
OK


2.CHECK PANEL SWITCH
E178228
  1. Enter the "Function Check/Setting" mode and select "Panel&Steering Switch Check Mode" (Click here).

  1. Operate the abnormal switch and check if the switch name and status are correctly displayed.

    OK:
    The switch name and status are correctly displayed as operated.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)