Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for HDD)

NAVIGATION SYSTEM (for HDD) > Voice is not Recognized

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK NAVIGATION SETTING


    E179910E01
  1. Enter the "Setup" screen by pressing the "SETUP" switch.

  1. Select "Voice".



    E179922E03
  1. Check that "Voice Recognition Guidance" is not off.

    OK:
    Voice Recognition Guidance is not off.



NG
TURN "Voice Recognition Guidance" ON
OK


2.CHECK MICROPHONE


    E182179E01
  1. Enter the "Microphone&Voice Recognition Check" mode (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)