Home › ENGINE ยท 2AD-FTV › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL FAN AND GENERATOR V BELT


  1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

    SST
    09216-42010  

    CAUTION:
    1. Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
    2. Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

    NOTICE:
    1. Make sure that the belt is set properly an each pulley.
    2. Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.



    A202342E01



2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A203781
  1. Install the front suspension member reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 979 kgf*cm , 71 ft.*lbf }



3. INSTALL REAR ENGINE UNDER COVER RH
  1. Install the under cover with the 2 clips.



4. INSTALL NO. 1 ENGINE UNDER COVER


    A203808
  1. Attach the 4 clips to install the engine cover.