Home › ENGINE ยท 2AD-FTV › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 clips and under cover.



3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A203781
  1. Remove the 4 bolts and front suspension member reinforcement.



4. REMOVE FAN AND GENERATOR V BELT


  1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the belt.

    SST
    09216-42010  

    CAUTION:
    1. Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
    2. Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

    NOTICE:
    Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.



    A202342E01